Open mfix, why only geometry, region,msh three modules?

[cgw]

You are in “SMS” (Segregated Mesher/Solver) mode which splits the workflow into two phases, meshing and solving. This allows you to inspect and accept/reject the mesh before going further with the simulation

Please see:

Missing Tabs in the latest mfix-22.1 version

I installed MFIX on my ubuntu 20.04 system and I’m missing the tabs on the left for boundary conditions, model setup, Initial conditions etc… [Screenshot from 2022-04-02 10-33-32] Is this a bug, or my installation went wrong, or is this the new version setup? if this is the newest version, how to input the fluids, solids etc… Thank you.