Hi. Running the job here did not lead to ‘NaN detected’. But it failed to converge (DT < DT_MIN).
Note the large number of warnings.
I’m seeing a large number of this warning:
Velocity exceeds limit: 100.00
To change the limit, adjust the scale factor MAX_INLET_VEL_FAC.
and this message:
The sum of mass fractions is not equal to one.
Note that you can scroll through the messages with the arrow and TAB keys.
The MAX_INLET_VEL_FAC message has been discussed here before, it most often is due to poor mesh quality. I suggest searching the forum for MAX_INLET_VEL_FAC.
– Charles